GearUP 1200W,12V, Pure Sine Wave Solar Inverter With 40A MPPT Charge Controller (Lithium & Acid Battery Supported) - GHT-12K12 Plus

GearUP 1200W,12V, Pure Sine Wave Solar Inverter In Bangladesh

The GearUP 1200W, 12V, Pure Sine Wave Solar Inverter In  Bangladesh. Get the original products at the most affordable price at Pixio and enjoy the quality with the promise of the best customer service in Bangladesh.

Specifications: 

• Product Type: DC to AC inverter and Battery Charger
• Input Voltage: 165-275VAC (220VAC)
• Maximum Ac Charge Current: 15A
• Battery Voltage: 12V DC
• DC Charge Voltage: 12~16VDC(12V)
• Output Frequency: 50Hz/60Hz automatic recognition
• Output Voltage: 220V
• Output Type: Single Phase 
• Waveform: Pure Sine Wave
• Inverter Efficiency: 90%
• UPS Transfer Time: ≤5ms
• Transformer type: Toroidal
• Surge power: 3 times the rated power
• Maximum PV Array Open Circuit Voltage: Max. 100V
• Maximum PV Array Power: 600W(12V)
• Maximum Solar Charge Current: 40A
• Maximum Charging Current: 55A
• Protection: Short Circuit/Overload/Overvoltage/Over Temperature
• Display: LCD+LED Display
• Communication Port: RS-485 for WiFi Dongle (Dongle NOT included)
• System Language: English/ Chinese

GearUP Inverter (GHT, GHT Plus, GFT Models) MODES Explain:

AC priority mode: In this operation mode, there is an AC input and battery power. The inverter will use the AC input first; Battery power is a backup. When the AC input is cut off, the inverter will switch to battery supply automatically. And the load will not stop. Like UPS function.

Battery Priority Mode: There is AC input, Solar, and battery power. Inverter will use (If there is solar power), will use solar power first. When solar is stop will use battery power. If no solar, then battery power is first to save on AC cost. When the battery voltage reaches the low voltage, the inverter will switch to an AC input supply automatically, and the load will not stop. AC input will not charge the battery in order to save on AC cost. The other day, solar was available and charged the battery. When the battery voltage is restored, the inverter will use the battery and solar supply again.

ECO Mode: The Inverter will check the load every 5 seconds. If the load is lower than 10% of the inverter (such as an inverter that is 3000W, the load is lower than 300W) inverter will stop output and check every 5 seconds. When the load is higher than 10%, the inverter will supply the load continuously.

Generator Mode: Because generator output voltage is not stable, in this mode, inverter AC input voltage is from 165V to 275V; in this range inverter will also use AC input and supply the AC output is 220V+-10%.

Unattended Mode: Normally used in places without people, such as mountains, Remote areas, Telecom stations, etc. Where we don’t use AC input, Battery voltage is reduced to low the low-voltage protection inverter will stop the AC output and standby. The other day, solar was available and charged the battery, and the voltage was restored. The inverter will supply the AC output auto. Don’t need to send people to turn on the inverter. In this mode, if connected with an AC input, the inverter will use the AC input first.

Note: If there is no MPPT/Solar input, ignore the solar function for that model of the inverter.